Breakout Boards

Set Descending Direction

Items 1-10 of 22

Page

AB Electronics Serial Pi Zero

Control the Raspberry Pi Zero over RS232 or connect to external serial accessories.
RS232 Master Port.
Mounting holes for use with the AB Electronics UK mounting kits (sold separately)
Stackable with other Raspberry Pi accessory boards.

AB Electronics IO Pi Zero

Configurable interrupt source - Interrupt-on-change from configured register defaults or pin changes
Polarity Inversion register to configure the polarity of the input port data
Configurable interrupt output pins - Configurable as active-high, active-low or open-drain
Stack up to 8 IO Pi boards on a single Raspberry Pi
External 5V Input with isolation pad

Proto-Pic micro:pixel Edge for micro:bit

Plug your micro:bit into the connector, upload your code using the neopixel library and you're good to go!
10 super high density WS2812B (NeoPixel) LEDs
Microbit is NOT Included

Pi Supply Gert VGA 666 Kit - Hardware VGA for Raspberry Pi

Useful solution for using a VGA screen/monitor with your Raspberry Pi
It is possible to drive this interface at the same time as the HDMI connection, so a dual screen setup is possible.
The VGA connection is driven natively in hardware over the GPIO pins
Capable of displaying 1080p60 VGA video with no CPU load.

AB Electronics 1 Wire Pi Plus

Buffered 5V I2C port.
External 5V power input for 1-Wire interface.
Stackable with other Raspberry Pi accessory boards.
1-Wire to I2C host interface with ESD protection diode.
2C address selection via solder jumpers.

AB Electronics RS485 Pi

Use the Raspberry Pi to control external RS-485 devices.
Mounting holes for use with the AB Electronics UK mounting kits (sold separately)
RS-485 Half Duplex Port.
Stackable with other Raspberry Pi accessory boards.
Up to 250 kbps transfer rate.

Proto-Pic micro:pixel 4x8 WS2812B Board for BBC micro:bit

Fully assembled with an edge connector
The micro:pixel board also has the micro:bits pins 0, 1 and 2 broken out along with 3v and ground which can accommodate a banana plug or croc clip.
The micro:pixel uses Pin0 as the LED data pin

RasPiO Duino Low Cost Easy Way into Arduino Programming on the Raspberry Pi

All the ports are clearly labelled and there are lots of options.
Each of the useful pins on the ATMega are broken out to a cluster of three holes
Small plug-on board for Raspberry Pi
72 point prototyping area, with GND, 3V3 and 5V rails, where you can add your own components.
Once programmed, it can be removed from the Pi and used on its own

AB Electronics Servo PWM Pi Zero

16-channel, 12-bit PWM controller for the Raspberry Pi
The PCA9685 contains 5 I2C address selection pins
Output frequency is programmable from a typical 40Hz to 1000Hz

Pi Supply PaPiRus Display Extension

PCB Dimensions: 3.4cm x 1.8cm x 0.4cm
Width: 2cm
Length: 20cm
This nifty kit allows you to break out the eInk/ePaper display from the PaPiRus boards.
Set Descending Direction

Items 1-10 of 22

Page