Hobbyist

Set Descending Direction

Items 1-10 of 64

Page

Pi Supply SNESPi Raspberry Pi Gaming Bundle with NES Classic USB Gamepads

This kit includes the classic SNESPi Case
Ultimate retro Raspberry Pi gaming bundle
Two NES classic styled gamepads which turns the Raspberry Pi into a fully fledged DIY games console

Pi Supply Flick Zero - 3D Tracking & Gesture pHAT for Raspberry Pi Zero

One line installer
Touch and Tap sensing
Compatible with Raspberry Pi A+, B+, 2B, 3B and 3B+ and all other Raspberry Pi boards with 40 GPIO pins (or compatible boards).
Gesture sensing up to 15cm
Communicates with the Raspberry Pi via I2C

Pi Supply PaPiRus HAT Case

Can be wall mounted
4 button actuators allow you to use the programmable buttons on the PaPirus HAT without the need to open up the case
All ports on the PaPiRus HAT and Raspberry Pi are accessible
Comes with 4 x rubber feet
A clear transparent top allows you to keep an eye on your ePaper project

Pi Supply JustBoom DAC

Includes both a DAC and headphone amplifie
Plug and play compatibility for ease of use
Powered by the 5v micro USB power supply - you probably already have one!
Full high quality audio 108kHz / 24bit (uses 384kHz/32bit DAC chip but this is limited due to the S/PDIF input)
No soldering required

Pi Supply MonsterBorg - The Ultimate Raspberry Pi Robot

No soldering required
Designed for the Raspberry Pi.
Mount for a Raspberry Pi camera
ThunderBorg Lid for 10xAA batteries
ThunderBorg 5A motor controller

Pi Supply Micro USB WiFi Dongle for the Raspberry Pi Zero

Blue Activity Indicator LED
Doesn't Foul on Micro USB Power Cable
Supports 64/128-bit WEP, WPA/WPA2 encryption methods and 802.1x authentication standards
Output: Micro USB Type B
External Casing Dimensions: 13.65mm x 23.00mm x 9.45mm

Pi Supply SNESPi Retro Raspberry Pi Gaming Bundle with SNES Gamepads

2 x Raspberry Pi Compatible SNES Controller
Raspberry Pi 3 Model B Plus
NOOBS 16GB Class 10 MicroSD Card
Official Raspberry Pi 5.1V 2.5A International Power Supply (for UK, EU, USA & AUS)
SNESPi Case for Raspberry Pi 3 (with cooling fan)

Pi Supply Motor Controller Board Kit for Raspberry Pi

This now pre-soldered and features a new and improved design breaking out the GPIO Pins to the side of the board.
Programming the board to drive a motor is as simple as turning a pin on or off.
Budget friendly motor controller

Pi Supply Raspberry Pi Touch Screen Case - White

Four screw fixings supplied for attachment to the touch screen
Easy clip rear cover to protect/access all internal connectors
Camera board connector slot
Cut-outs for all connections
Renders the touch screen and Pi board portable

Pi Supply Spring Antenna | 850 - 1850MHz

RF Cable: RG1.13 cable
Cable OD: 1.1mm
Standing wave ratio / S.W.R.2.0
Length:12cm
Impedance: 50
Set Descending Direction

Items 1-10 of 64

Page