Adafruit Push-Button Power Switch Breakout
• Easy set up: connect power source to Ground and IN, then the load from Ground to OUT• Uses a 3A P-FET to connect and disconnect IN pin to OUT pin• Works from 3V to 14V DC and up to 3A• Includes a 12mm tactile switch but you can solder in your own if needed• 0.5uA quiescent current draw
• On-board red LED lights up when active
• Fourth KILL pin will turn off the FET when 1 or more volts is applied, can be used to allow your project to turn itself off!The Adafruit Push-button Power Switch is a tidy little design that lets you control a DC power source using an everyday tactile button. The breakout uses a latching analog circuit that is triggered by a push of the button. Press once to turn on, then press again to turn off. The circuit uses a 3A P-FET to connect and disconnect the IN pin to the OUT pin. Works great from 3V to 14VDC and up to 3A (although the FET gets a little toasty at continuous 3A draw) yet has only 0.5uA quiescent current draw.
Using it is easy: connect the power source to Ground and IN, then the load from Ground to OUT. We include a 12mm tactile switch that works well but you can solder in your own switch as well. Press the button (or short the button pins) to alternate between on or off. A on-board red LED will light up when active so you know its working. There's a fourth KILL pin, which you can use to turn off the load and/or keep it off even if the button is pressed. When 1 or more volts is applied it will instantly turn off the FET. This allows your project to turn itself off.
Comes with a assembled & tested bread-board friendly breakout board with four mounting holes, a 12mm tactile button, and some 0.1" male header you can solder to the board to plug it into a breadboard.
The power switch is an elegant way to control power to your project, but there are some things to keep in mind: since there is a pass FET, this is only for 3-14V DC voltages. This is not a mechanical switch so there is no air-gap isolation. There is a 'body diode' in the pass FET so if the load has a voltage on it that is higher than the input voltage, current will flow back to the input. There is built-in debouncing but very bouncy switches can be annoying as they will turn on and off fast instead of latching.
Why not tell us and our B2B sales team about your specific business needs and expectations?
At Maplin, we’re always looking for innovations and technology that can help your business work more efficiently.
With a dedicated business team and special services available only to business customers, you can access our electronics and technology solutions through our wide network of over 200 stores, our website with more than 20,000 products or though your personal account manager over the phone.
Working with organisations for nearly 30 years, Maplin offers a nationwide range of benefits to our business users:
- 30 day EOM credit account
- volume discount pricing
- online and in-store use of account
- one-to-one account management
- bespoke product sourcing and branding
- free delivery on orders over £10
- scheduled and forward ordering service
Contact our business team on
0333 400 9740 to open an account or discuss your business needs.
To receive your free copy of the Maplin Catalogue just call 0333 400 9740.