Find similar products here

OpticalCON DUO 2 Fiber Single Mode Coupler

Price match guranteePrice match guarantee

We can price match this item if found elsewhere. Call us on:

0333 400 9500

Quoting product code: A58QQ

£203.99

About this product

Overview

  • These allow opticalCON DUO cables to be joined inline
  • All are fully wired with four copper wires of 0.75mm sq. in addition to the two fibres and are IP65 rated when mated

Product overview

• These allow opticalCON DUO cables to be joined inline
• All are fully wired with four copper wires of 0.75mm sq. in addition to the two fibres and are IP65 rated when mated

Neutrik have improved on the original opticalCON with the introduction of the opticalCON ADVANCED range. All ADVANCED cable connectors have an extremely rugged protective rubber coating with integral anti-kink strain relief boot and a rubber-coated metal, latching cap attached by a steel lanyard (The metal latching cap and connector front housing is available separately to upgrade older assemblies, see SCNO below). The opticalCON ADVANCED system is designed around the duplex LC optical connector plus, optionally, four copper conductors, housed in a ruggedised latching body. They are suitable for point-to-point audio, data or camera connection use in all environments such as studio floors, touring, rental and outside broadcast. The cable connectors are supplied pre-assembled only, onto a choice of fibre or fibre/copper hybrid cables. The chassis connectors act as a feed-through and may be mated at the front with Neutrik opticalCON DUO leads for harsh applications, or standard single or duplex LC leads for simple patching. The chassis connector rear accepts standard single or duplex LC connectors and has solder cup termination for copper conductors.

Fibres within both chassis and cable connectors are protected from dirt when unmated by integral, automatic, sealing-shutters with silicone gaskets, which lift when the connectors are mated. The shutters also block laser emission, should a source be left switched on inadvertently. Connector housings have an extremely hard-wearing black chrome finish.

Multimode (MM), 50/125 micron, PC style assemblies are available as well as singlemode (SM), 9/125 micron, assemblies, also in PC style. Please note that LC cables fitted to the rear of the chassis connector MUST match the mating opticalCON ADVANCED DUO assembly type. Connections between MM 50 micron and either 62.5 micron or other fibre sizes may cause losses of 3dB or more.

Specification

Title
NAO2*-H1W-A
Connection Type
Adapter
Gender
female
Electrical
Contact resistance
< 7 mO (inner)
Dielectric strength
1,5 kVdc
Insulation resistance
> 2 GO (initial)
Rated current per contact
6 - 10 A (Contact 1+4 10 A, Contact 2+3 6 A)
Rated voltage
50 V (1)
Mechanical
Insertion force
< 45 N
Withdrawal force
< 45 N
Lifetime
> 1000 mating cycles
Locking device
Push-Pull
Material
Contact plating
0.2 µm Au over 2 µm Ni
Contacts
Bronze (CuSn6)
Insert
Polyamide (PA 6, PBT 30 % GR, PBT 50 % GR)
Shell
AlMgSi 0.5, black plated
Split sleeve
ceramics
Environmental
Temperature range
-30 °C to +80 °C
Optical
Insertion loss
< 0.4 dB / connection
Optical connector
LC-Duplex
Product specific
(1)
Not compatible to the SMPTE standard, suitable for indoor studio applications acc. IEC 60664-1 (pollution degree 1, over voltage category 1)

Downloads