Bundle: ProSound BP2K Power Amplifier - 2000W + 2x Alpha Twin 15" 4 Ohm 600W RMS Passive Speaker

About this product

This bundle contains:
● 1x ProSound BP2k Power Amplifier 2000w
● 2x ProSound Delta Plywood 10" Trapezoidal 400W RMS Full Range Passive Speaker

ProSound BP2K Power Amplifier - 2000W

The ProSound BP4K 2 Channel Power Amplifier is a 2-channel Class D Power Amplifier with 3000 watts RMS of output power. At 4 ohms the BP4k 2 x 1500 watts at 8 ohms and 2 x 1000 watts of power. Professional amplification requires locking powercon input not IEC kettle lead. A fast push-to-make circuit breaker protects the amplifier at the rear mains input.

Class D amplification ensures a truly powerful sound inside a 1u compact and lightweight unit. With full protection against short-circuiting, overheating, DC voltage, power on/off transients and soft-start, the BP4k power amp ensures a safe, reliable performance.

There are level controls for each channel and the steel chassis housing also includes 2 x XLR inputs and 2 x SpeakOn outputs.

Power, signal and clip lights reveal the status of each of the 2 channels whilst 4 hi-speed thermally controlled fans draw air in through the front and out at the rear.

Features

2 x 1500 Watts RMS into 4 Ohms
2 x 1000 Watts RMS into 8 Ohms
110v/240v switchable
Independent gain on each channel
Light and compact only 5kg in total
Frequency Range: 30Hz - 20kHz ±1 dB
Intelligent fans switch in and out dependent on the heat generation automatically to ensure cool running
Limiters protect the BP4K from damage by moving to protect mode when THD is more than 0.5%
Each of the 2 channels has an independent clip, protection and signal indication.
Strong 1u four-bolt M6 rack ears for easy touring rack installation
2 x XLR balanced Neutrik analogue audio inputs
2 NL4 Neutrik speakON output connectors

Protection:

Soft Start
DC
Short Circuit
Overload
Distortion limiting
Overheating
VHF

Designed to run down to 200v at which point the amplifier will go into protect mode. As soon as the voltage is restored you can use the amplifier again. This is important if you are running a power amplifier off a generator with an unstable power regulator.

Always use a power conditioner with this product for your safety and to protect your expensive PA.

1U amplifiers must be kept cool! High-speed fans are built-in but the only source of airflow is from the front vents so it is of the utmost importance to check monthly and keep these clean and free from clogging up with dust and dirt. Amplifiers will not be repaired under warranty if they fail due to overheating caused by poor maintenance and dust/dirt blocking the cooling vents.

2x ProSound Alpha Twin 15" 4 Ohm 600W RMS Passive Speakers

● Heavy duty carpet covered trapezoidal design with powder coated metal grill and corners
● Full range 2-way speaker with titanium domed HF compression driver
● Speakon and 1/4" jack sockets for input and linking
● Power peak: 2400W
● Dimensions: 45cm x 43cm x 124cm

The ProSound Alpha Twin 15" 4 Ohm 600W RMS Passive Speaker is the perfect solution for delivering clear, powerful sound to audiences of up to 500 when used as a pair. All the drivers are made by us at BishopSound using British Paper Cones. The HF unit is the BRC175 which with its titanium dome gives superb performance and clarity. Weighing only 30kg, these are easy to lift and the tough grill protects the drivers.